D-I-Y Basement Crack Repair Kits-Epoxy
Epoxy Concrete Crack Repair Materials
Epoxies are used to structurally repair a concrete foundation crack and to also stop water from entering a concrete crack. The cured epoxy will completely fill the concrete crack and return the wall to its pre-cracked strength.
The high tensile strength, bonding strength and compressive strength make epoxies excellent for reinforcing concrete cracks. Many times the repaired concrete crack is stronger than the concrete around it.
Epoxies are formulated to different viscosities to allow for a wide variety of crack widths.
Epoxy Foundation and Basement Crack Repair Advantages
- Structurally re-inforce concrete
- Stop water leaks
- Fills the crack completely
Where to Use Epoxies
- Concrete foundation cracks
- Delaminated concrete
- Manholes
- Sewers
- Concrete tunnels
A-Tech 212 LV Epoxy
@ $186.00
6 Cartridges/Case
A-Tech 212 LV is a two component, 100% solids, low viscosity, moisture insensitive epoxy. It meets ASTM C-881. The product exhibits a high modulus of elasticity. It is recommended for use in hairline cracks up to 5/16” wide. It has a fast setting gel time to prevent materials from leaking out of cracks. This greatly reduces the amount of material used versus other epoxies.
Requires 632 Static Mixer
Lock Nuts Included
Advantages:
- Fast gel time prevents leaking out of cracks for extended amount of time
A-Tech 212 EHV Epoxy
@ $186.00
6 Cartridges/Case
A-Tech 212 EHV is a two component, 100% solids, extra high viscosity, moisture insensitive epoxy. It meets ASTM C-881. The product exhibits a high modulus of elasticity. It is recommended for use in cracks greater than 1/4” wide. It has a fast setting gel time to prevent materials from leaking out of cracks. This greatly reduces the amount of material used versus other epoxies.
Uses 1224 Static Mixer
Lock nuts included
Advantages:
- Fast gel time prevents leaking out of cracks for extended amount of time
A-Tech 0101 Gel
@ $210.00
8 Cartridges/Case
A-Tech 0101 Gel is a two component, 100% solids moisture insensitive epoxy. It meets ASTM C-881. The product exhibits a non-flow property when uncured. This means the product will not flow out cracks prior to curing. It is recommended for use in cracks greater than 5/16” wide.
Uses 1224 Static Mixer
Lock nuts included
